2 days ago Be among the first 25 applicantsGet AI-powered advice on this job and more exclusive features.Direct message the job poster from Owen DanielsResponsibilities:RF Subsystem Design: Design RF front-end modules (LNAs, PAs, filters, mixers, frequency converters) across Ku and Ka for ground terminal applications.System Analysis: Perform System analysis, propagation modelling, Embedded RF component designs and RF performance simulations using System Vue, ADS, and MATLAB.Prototyping & Testing: Develop RF circuit designs including schematic designs and conduct RF performance validation using VNAs, spectrum analysers, signal generators, and satellite modems.EM Simulation: Perform RF System simulations using tools like System Vue, Keysight ADS and HFSS.Simulation & Measurement Analysis: Analyse simulation results and experimental data using MATLAB, Python, or other similar tools.Cross-Functional Collaboration: Support integration with digital modems, Antenna systems, and mechanical enclosures for terminal-level performance optimisation.Documentation & Reporting: Prepare reports and presentations on designs, simulations, measurements, and performance.Productisation: Work closely with hardware, mechanical and manufacturing teams to ensure designs are optimised for manufacturability, cost, and reliability.Compliance & Certification: Ensure designs meet international SATCOM regulatory standards (FCC, ITU, ETSI), EMC and environmental qualifications for rugged platforms.Required Skills:7-8+ years of experience in RF/microwave design, preferably in satellite ground terminals or SATCOM systems.Deep understanding of analog and RF circuit design (LNAs, mixers, phase shifters, VCOs, PAs, op-amps, etc.), including noise, linearity, and impedance matching.High proficiency with RF test equipment: signal generators, spectrum analysers, and network Analysers.Proficiency in System Vue, ADS, MATLAB or similar simulation/modelling tools.Expert in designing RF hardware for Ku, Ka SATCOM applications.Strong knowledge of RF propagation, RF link budgets, and phased array principles.Demonstrated ability to balance performance with design-for-manufacturability (DFM) and cost-effectiveness.Preferred Skills:Experience with PCB layout for RF and microwave circuits using Altium or similar design software.Programming skills in MATLAB, Python, or similar languages for data analysis, automation, and simulation support.Experience with EM Simulations tools such as HFSS or CST.Seniority levelMid-Senior levelEmployment typeContractJob functionDesignIndustriesDefense and Space ManufacturingSpace Research and TechnologyComputers and Electronics Manufacturing #J-18808-Ljbffr